Burst Strength Attachment (ASTM D). Brochure Share. Request Info . Product Details Standards Get a Quote. Product Details. Burst Strength. ASTM D determines the measurement for bursting strength with a ball burst strength tester of textiles or garments that exhibit a high degree of ultimate. Page 1. — — 27 —>. Ø K-. k— ASTM D Fixture.
|Published (Last):||21 August 2017|
|PDF File Size:||9.11 Mb|
|ePub File Size:||6.94 Mb|
|Price:||Free* [*Free Regsitration Required]|
Other materials with established test values may be used for this purpose. Within the test, the inch-pound units are shown in parentheses.
ASTM D – Ball Burst Puncture Fixture
The test samples used should be as homogeneous as possible, drawn from the material from which the disparate test results were obtained, and randomly assigned in equal numbers to the laboratories for testing. This standard does not purport to address qstm of the safety concerns, if any, associated with its use.
For the measurement of bursting strength astm d3787 a hydraulic testing machine, refer to Test Method Astm d3787 The test results from the two laboratories should be compared using a statistical test d37877 unpaired data at a probability level chosen prior to the testing series.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of astm d3787 standard.
Historical Version s – astm d3787 previous versions of standard. In cases of disagreement arising from differences in values reported ast the purchaser and the seller when using Test Method D for acceptance testing, the statistical bias, if any, between the laboratory of the purchaser and the laboratory of the seller should be determined with comparison based on testing specimens randomly drawn from one sample of material astm d3787 the type being evaluated.
Link to Astm d3787 This link will always route to the current Active version of the standard.
If a bias is astm d3787, either the cause must be determined and corrected or future test results must be adjusted in astm d3787 of known bias. The values stated r3787 each system are not exact equivalents; therefore, each system may be used independently of the other.
Combining values from the two systems may result in nonconformance within the specification.
The kind of force transfer and strength that occur when knitted goods are worn is prevented by clamping them as directed in this test method.
Test Method Astm d3787 is considered satisfactory for acceptance testing of commercial shipments of textiles fabrics for bursting strength since the method has been used extensively in the trade for acceptance testing. It is the astm d3787 of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.